Table of Contents
Advertisement
2. WIRING
2.1.2
Control cable, Monitor cable and External connection
The control, monitor and external equipments connection ports are behind the con-
nector cover on the rear panel. Access the ports and connect cables as shown in the
procedure on the following page.
Note: The processor unit must be mounted indoors to do this connection because of
reduction in waterproofing.
1. Disassemble the waterproofing cover.
The assembled parts are numbered from 1 to 4. These parts should be installed
in numerical order, as described in this procedure, or the waterproofing rating is
reduced.
2. Pass the cables through the en-
trance of connector cover.
3. Connect the cables to the re-
spective ports.
4. Fasten the six binding screws to
fix the connector cover.
5. Attach the fixing plate 1 to the entrance of the connector cover.
Note: Face the markings outwards.
6. Pass the cables through appropriate holes in the gasket.
2-2
Binding screw
(6 pcs.)
Fixing plate 2
Fixing metal
Binding screw
(3 pcs.)
Connector cover
Path the cables through the connector
Face markings outward
Connector cover
Fixing plate 1
Gasket
Advertisement
Table of Contents
