How To Use Marks; Heading Line; Stern Mark; North Mark - Furuno FAR-1416 Operator's Manual

1.41

How to Use Marks

1.41.1

Heading Line

The heading line is displayed in all display modes and shows your heading. The head-
ing line appears above own ship in the head up mode and head up TB mode. The
heading line appears under the own ship position in the stern up mode. In the north
up, true motion and course up modes, the heading line moves according to the move-
ment of the vessel.
Erase the heading line temporary
Press and hold the HL OFF key to hide the heading line. The heading line and markers
on the radar screen are erased while the key is held.
1.41.2

Stern mark

The stern mark appears opposite to the heading line when the mark is active. To dis-
play or erase the stern mark, do the following:
1. Open the [MAIN MENU].
2. Select [CURSOR/OWN SHIP MARK], then press the
left button.
3. Select [OWN SHIP MARK], then press the left button.
4. Select [STERN MARK], then press the left button.
5. Select [ON] or [OFF], then press the left button.
6. Press the MENU key to close the menu.
1.41.3

North mark

The north mark appears with short broken line inside of measure ring. The north mark
moves while the head-up mode is activated.
1.41.4

Cursor bearing scale

The bearing scale is displayed in degrees or 16 compass points.
1. Open the [MAIN MENU].
2. Select [CURSOR/OWN SHIP MARK], then press the left button.
3. Select [BEARING CURSOR], then press the left button.
4. Select [360°] or [16 POINTS], then press the left button.
360°
1. OPERATIONAL OVERVIEW
[CURSOR/OWN SHIP MARK]
1. BACK
2. [CURSOR]
3. [EBL/VRM]
4. [PI LINE]
5. [NET CURSOR]
6. BEARING CURSOR
360° / 16 POINTS
7. RANGE RING
OFF/STD./MANUAL
4
8. [OWN SHIP MARK]
9. [BARGE MARK]
16 points
1-57