How To Select A Pulselength; How To Change The Pulselength - Furuno FAR-1416 Operator's Manual

2. Move the cursor onto the [RANGE] box at the top-left corner of the screen.
3. Press the left button to lower the range; the right button to raise the range.
You can also select the range by rotating the scrollwheel then pressing the left
button when the cursor is inside the range box.
1.11

How to Select a Pulselength

The pulselength in use appears at the upper-left position of the screen using the indi-
cations shown in the table below.
Appropriate pulselengths are preset to individual range scales and function keys. If
you are not satisfied with the current pulselength settings, you can change them as
shown in the procedure below.
1.11.1

How to change the pulselength

The pulselength can be changed using the procedure below.
1. Place the cursor in the [PULSE] box at the top left corner of the screen.
2. Press the left button, right button or rotate the scrollwheel to cycle through
pulselengths. The order in which the pulselengths are cycled is shown in the table
below.
Method
Left button
Right button
Scrollwheel (up)
Scrollwheel (down)
Note: Available pulselengths are restricted depending on the range.
See the table below for details.
Range
1.5 NM
3 NM
1.5
Range
NM
RING 0.5
(PULSE) indication
S (short pulse)
M (medium pulse)
L (long pulse)
Cycle order
Decreases the pulselength.
Increases the pulselength.
Increases the pulselength.
Decreases the pulselength.
(PULSE) indication
S, M
M, L
1. OPERATIONAL OVERVIEW
Range Box
Range ring
interval
1-15