Reload The Data From Usb Flash Memory - Furuno FAR-1416 Operator's Manual

6. DATA SAVE AND READ
6.3.4

Reload the data from USB flash memory

To reload the data from USB flash memory to internal memory, do the following pro-
cedure.
1. Insert the USB flash memory to the USB port.
2. Press STBY/TX key to change to st-by mode.
Following procedures are not enabled at TX mode.
3. Open the [MAIN MENU].
4. Select [MEMORY REC./PLAY.], then press the left button.
5. Select [USB MEMORY PLAYBACK], then press the left button.
6. Select the item to save, then press the left button.
7. Select [ADD] or [OVERWRITE], then press the left button.
[ADD]: adds data onto present data.
[OVERWRITE]: overwrites ontopresent data.
Note: The addition of mark/track has a limit of 30,000 points. If the number of mark
reaches the limit, the earliest mark data is overwritten.
8. Repeat the step 5 and 6 for other data loading.
9. Select [SEL DATUM], then press the left button.
10. Select [WGS-84] or [TOKYO], then press the left button.
In generally, default setting WGS-84 is available.
11. Select the file to load from the data selection list.
The confirmation message "LOAD FILE. ARE YOU SURE?" appears.
12. Select [RUN], then press the left button.
A message informing you that the load is in progress is displayed, followed by a
confirmation that the load process is complete. However the screenshot data is
large, it takes more time for storage.
13. Confirm the message, then press the left button.
6-8
USB MEMORY PLAYBACK
PLAY OWN TRK
: ADD
PLAY OTHER TRK
: ADD
PLAY MARK/TRACK
: OVERWRITE
PLAY ROUTE/WPT
: OVERWRITE
SEL DATUM
: WGS-84
UPLOAD SETTING
: OVERWRITE
DATA SELECTION
FILE NAME OWN TRK OTR TRK
201607231746 5370 0
CURRENT USAGE OWN TRK
OTHER TRK (CONS)
OTHER TRK (AIS)
OTHER TRK (TT)
OTHER TRK (GPS BUOY)
MARK/LINE
TURN WHEEL : SELECT PRESS LEFT BUTTON : ENTER
PRESS RIGHT BUTTON : CLOSE
SELECT THE FILE TO RECORD
NO
NO
ADD NO
NO
TOKYO
NO
SEL PAGE_
MARK WPT ROUTE
0 0 0
: 1037 /30000
: 0 /10000
: 32 /10000
: 16 /10000
: 0 /10000
: 6 /30000