Data Reloading - Furuno FAR-1416 Operator's Manual

6. DATA SAVE AND READ
6.5

Data Reloading

You can load data from other equipment to internal memory in this equipment.
Note: The data transfer should be done by a technician. Contact your local dealer to
do this procedure.
1. Insert the USB memory which has the required data to the USB port on control
unit.
2. Open the main menu.
3. Select [MEMORY REC./PLAY.], then press the left but-
ton.
4. Select [NEXT], then press the left button.
5. Select [RELAY DATA], then press the left button.
GD-X80 includes GD-280 (BB), GD-380 and GD-680.
Note: [GD-X80(FLOPPY)], [GD-188(FLOPPY)] and [GD-
300/700] are unusable.
6. Select the model, then press the left button.
Following figure shows an example for [GD-X80(CARD)].
7. Select the item preferred, then press the left button.
8. Select [YES], then press the left button.
9. Repeat step 7 and 8 to load other data.
10. Select [SEL DATUM], then press the left button.
11. Select [WGS-84] or [TOKYO], then press the left button.
12. Select the file to load, then press the left button.
13. Select [RUN], then press the left button.
The confirmation message appears.
14. Close the menu.
6-12
GD-X80 (CARD)
REC OWN TRK
: YES
REC OTHER TRK
: YES
REC MARK/TRACK
: YES
REC ROUTE/WPT
: YES
SEL DATUM
: WGS-84
DATA SELECTION
FILE NAME OWN TRK OTR TRK
CURRENT USAGE OWN TRK
OTHER TRK (CONS)
OTHER TRK (AIS)
OTHER TRK (TT)
OTHER TRK (GPS BUOY)
MARK/LINE
TURN WHEEL : SELECT PRESS LEFT BUTTON : ENTER
PRESS RIGHT BUTTON : CLOSE
SELECT THE FILE TO RECORD
NO
NO
NO
NO
TOKYO
SEL PAGE_
MARK WPT ROUTE
: 1037 /30000
: 0 /10000
: 32 /10000
: 16 /10000
: 0 /10000
: 6 /30000
[RELAY DATA]
1. BACK
2. GD-X80(CARD)
3. GD-X80(FLOPPY)
4. GP-3500
5. GP-3000 SERIES
6. GD-500
7. GD-188(CARD)
8. GD-188(FLOPPY)
9. FAR-21x7
10. GD-300/700