Firepower 8000 Series Devices - Cisco 7010 Installation Manual

Chapter 7 Hardware Specifications
Table 7-33 Firepower 7115, 7125, and AMP7150 Physical and Environmental Parameters (continued)
Parameter
Acoustic noise
Operating shock
Airflow

Firepower 8000 Series Devices

The Firepower 8000 Series devices use network modules (NetMods) that contain either copper or fiber
sensing interfaces. The devices can be shipped fully assembled or you can install the modules. Assemble
your device before installing the Firepower System. See the assembly instructions shipped with your
modules.
Some 8000 Series devices can be stacked to increase the capability of the system. For each stacking kit,
you replace a NetMod with a stacking module and cable the devices together using the 8000 Series
stacking cable. See
The Firepower 8000 Series device can be delivered on a variety of chassis:
•
•
•
•
•
•
•
•
•
Description
64 dBA at full processor load, normal fan operation
Meets GR-63-CORE 4.6 Acoustic Noise
Complies with Bellecore GR-63-CORE standards
3 3
140 ft (3.9 m ) per minute
Airflow through the appliance enters at the front and exits at the rear with no side
ventilation.
Using Devices in a Stacked Configuration, page 4-13
AMP8050 is a 1U chassis and can contain up to three modules.
Firepower 8120, 8130, 8140, and AMP8150, also known as the 81xx Family, is a 1U chassis and can
contain up to three modules. For the Firepower 8140 only, you can add a stacking kit for a total 2U
configuration.
Firepower 8250, part of the 82xx Family, is a 2U chassis and can contain up to seven modules. You
can add up to three stacking kits for a total 8U configuration.
Firepower 8260, part of the 82xx Family, is a 4U configuration with two 2U chassis. The primary
chassis contains one stacking module and up to six sensing modules. The secondary chassis contains
one stacking module. You can add up to two stacking kits for a total 8U configuration.
Firepower 8270, part of the 82xx Family, is a 6U configuration with three 2U chassis. The primary
chassis contains two stacking modules and up to five sensing modules. Each secondary chassis
contains one stacking module. You can add one stacking kit for a total 8U configuration.
Firepower 8290, part of the 82xx Family, is an 8U configuration with four 2U chassis. The primary
chassis contains three stacking modules and up to four sensing modules. Each secondary chassis
contains one stacking module. This model is fully configured and does not accept a stacking kit.
Firepower 8350 and AMP8350, part of the 83xx Family, is a 2U chassis and can contain up to seven
modules. You can add up to three stacking kits for a total 8U configuration.
Firepower 8360 and AMP8360, part of the 83xx Family, is a 4U configuration with two 2U chassis.
The primary chassis contains one stacking module and up to six sensing modules. The secondary
chassis contains one stacking module. You can add up to two stacking kits for a total 8U
configuration.
Firepower 8370 and AMP8370, part of the 83xx Family, is a 6U configuration with three 2U chassis.
The primary chassis contains two stacking modules and up to five sensing modules. Each secondary
chassis contains one stacking module. You can add one stacking kit for a total 8U configuration.
Firepower 8000 Series Devices
for more information.
Firepower 7000 and 8000 Series Installation Guide
7-21