Cisco 7010 Installation Manual page 133

Chapter 7 Hardware Specifications
Figure 7-22
The following table describes the features that appear on the rear of the appliance.
Table 7-38
Feature
VGA port
USB 2.0 ports
RJ45 serial port
(81xx Family and 82xx
Family)
RS232 serial port
(83xx Family)
10/100/1000 Ethernet
management interface
Redundant power
supplies
Grounding locations
The 10/100/1000 management interface is located on the rear of the appliance. The following table
describes the LEDs associated with the management interface.
Firepower and AMP 83xx Family (Chassis: PG35-2U-AC/DC) Rear View
Firepower 8000 Series System Components: Rear View
Description
Allows you to attach a monitor, keyboard, and mouse to the device, as an
alternative to using the serial port, to establish a direct
workstation-to-appliance connection.
Allows you to establish a direct workstation-to-appliance connection (using
an RJ45 to DB-9 adapter) for direct access to all of the management services
on the device. The RJ45 serial port is used for maintenance and configuration
purposes only and is not intended to carry service traffic.
Allows you to establish a direct workstation-to-appliance connection for
direct access to all of the management services on the device. The RJ232
serial port is used for maintenance and configuration purposes only and is
not intended to carry service traffic.
Provides for an out-of-band management network connection. The
management interface is used for maintenance and configuration purposes
only and is not intended to carry service traffic.
Provides power to the device through an AC power source. Looking at the
rear of the chassis, power supply #1 is on the right and power supply #2 is
on the left.
Allows you to connect the appliance to the Common Bonding Network. See
the Power Requirements for Firepower Devices, page A-1
information.
Firepower 8000 Series Devices
Firepower 7000 and 8000 Series Installation Guide
for more
7-27