Cisco 7010 Installation Manual page 136

Firepower 8000 Series Devices
Table 7-42 AMP8x50 and 81xx Family Physical and Environmental Parameters (continued)
Parameter
Cooling requirements
Acoustic noise
Operating shock
Airflow
The following table describes the physical attributes and environmental parameters for Firepower 82xx
Family and the Firepower and AMP 83xx Family devices.
Table 7-43 Firepower 82xx Family and Firepower and AMP 83xx Family Physical and Environmental Parameters
Parameter
Form factor
Dimensions (D x W x H)
Weight maximum
installed
Copper 1000BASE-T
configurable bypass
NetMod
Fiber 10GBASE
MMSR or SMLR
configurable bypass
NetMod
Fiber 1000BASE-SX
configurable bypass
NetMod
Fiber 40GBASE-SR4
configurable bypass
NetMod
Copper 1000BASE-T
non-bypass NetMod
Firepower 7000 and 8000 Series Installation Guide
7-30
Description
1725 BTU/hour
You must provide sufficient cooling to maintain the appliance within its required operating
temperature range. Failure to do this may cause a malfunction or damage to the appliance.
Max normal operating noise is 87.6 dB LWAd (high temperature).
Typical normal operating noise is 80 dB LWAd.
No errors with half a sine wave shock of 2G (with 11 ms duration)
3 3
160 ft (4.5 m ) per minute
Restriction of the airflow such as blocking the front or back or enclosing the unit in a cabinet
without sufficient clearance may cause the unit to overheat, even if the ambient temperature is
in the operating range.
Airflow through the appliance enters at the front and exits at the rear. The minimum
recommended clearance in the front and back is 7.9 in.
(20 cm). This minimum can only be used if you can ensure a supply of low temperature air at
the front of the appliance.
Description
2U
29.0 in. x 17.2 in. x 3.48 in. (73.5 cm x 43.3 cm x 88.2 cm)
82xx Family: 58 lbs (25.3 kg)
83xx Family: 67 lbs (30.5 kg)
Quad-port Gigabit copper Ethernet configurable bypass interfaces in a paired configuration
Cable and distance: Cat5E at 50 m
Dual-port fiber configurable bypass interfaces with LC connectors
Cable and distance:
LR is single-mode at 5000 m (available)
SR is multimode fiber (850 nm) at 550 m (standard)
Quad-port fiber configurable bypass interfaces1000BASE-SX with LC connectors
Cable and distance: SX is multimode fiber (850 nm) at 550 m (standard)
Dual-port fiber configurable bypass interfaces with OTP/MTP connectors
Cable and distance:
OM3: 100 m at 850 nm Multimode
OM4: 150 m at 850 nm Multimode
Quad-port Gigabit copper Ethernet non-bypass interfaces in a paired configuration
Cable and distance: Cat5E at 50 m
Chapter 7 Hardware Specifications