Cisco 7010 Installation Manual page 114

Firepower 7000 Series Devices
Figure 7-7
Table 7-11
A
B
C
D
The front panel of the chassis houses LEDs, which display the system's operating state. The following
table describes the LEDs on the front panel.
Table 7-12 Firepower 7110 and 7120 Front Panel LEDs
LED
NIC activity (1 and 2)
System status
Reset button
Hard drive activity
System ID
Power button and LED
Firepower 7000 and 8000 Series Installation Guide
7-8
Firepower 7110 and 7120 Front Panel
Firepower 7110 and 7120 Front Panel Components
USB 2.0 connector
Reset button
NIC2 activity LED
System status LED
Description
Indicates whether there is any network activity:
• A green light indicates there is network activity.
• No light indicates there is no network activity.
Indicates the system status:
No light indicates the system is operating normally, or is powered off.
•
A red light indicates a system error.
•
See the Table 7-13Firepower 7110 and 7120 System Status, page 7-9
Allows you to reboot the appliance without disconnecting it from the power supply.
Indicates the hard drive status:
A blinking green light indicates the fixed disk drive is active.
•
An amber light indicates a fixed disk drive fault.
•
If the light is off, there is no drive activity or the system is powered off.
•
Helps identify a system installed in a high-density rack with other similar systems:
A blue light indicates the ID button is pressed and a blue light is on at the rear of the
•
appliance.
No light indicates the ID button is not pressed.
•
Indicates whether the appliance has power:
A green light indicates that the appliance has power and the system is on.
•
• A blinking green light indicates that the appliance has power and is shut down.
• If the light is off, the system does not have power.
Chapter 7
E NIC1 activity LED
F Hard drive activity LED
G ID button
H Power button and LED
for more information.
Hardware Specifications