Allowing Network Reconfiguration Using The Lcd Panel - Cisco 7010 Installation Manual

Network Configuration Mode
For IPv4, the LCD panel displays the following:
For IPv6, the LCD panel displays the following:
Edit the subnet mask or prefix the same way you edited the IP address, and press the check mark key to
Step 8
accept the changes.
The LCD panel displays the following:
Edit the default gateway the same way you edited the IP address, and press the check mark key to accept
Step 9
the changes.
The LCD panel displays the following:
Step 10 Press the check mark key to save your changes.

Allowing Network Reconfiguration Using the LCD Panel

Because it presents a security risk, the ability to change network configuration using the LCD panel is
disabled by default. You can enable it during the initial setup process (see
Process, page
To allow network reconfiguration using a device's LCD panel:
After you complete the initial setup of the device, log into the device's web interface using an account
Step 1
with Administrator privileges.
Select
Step 2
The Information page appears.
Click
Step 3
The Network Settings page appears.
Under LCD Panel, select the
Step 4
warning appears, confirm that you want to enable this option.
For information on the other options on this page, see the Firepower Management Center Configuration
Tip
Guide.
Click
Step 5
Firepower 7000 and 8000 Series Installation Guide
6-6
Subnet Mask: - +
000.000.000.000 X
Prefix: - +
000.000.000.000 X
Default Gateway - +
000.000.000.000 X
Save?
X
5-2), or using the device's web interface as described in the following procedure.
Admin
Access:
System > Local > Configuration
.
Network
Allow reconfiguration of network configuration
.
Save
Chapter 6
.
Using the LCD Panel on a Firepower Device
Understanding the Setup
check box. When the security