Entering Location Manually - Hughes HX50 Installation Manual

Chapter 4 • Commissioning the HX50/HX100 Remote Terminal
30
1037106-0001 Revision B.03-Draft
b. Enter the correct latitude and longitude for your location
and click Next.
Figure 19: Entering location manually
3. At the Satellite Parameters screen shown in Figure 20, click
the
Satellite Transponders
satellite and transponder listed either on the work order or in
the installation specification, and click Next.
The satellite parameters should have been provided to you in
either a technical update e-mail or an installation
specification. If the satellite and transponder for your
installation are not listed in the drop-down menu, and you
were not provided with an
steps a through d below to enter the satellite parameters
manually.
a. Select the
on the Satellite Parameters screen.
drop-down menu, select the
sbc.cfg
Enter satellite parameters manually
file, you must complete
check box