Overview Of Entering Installation Parameters - Hughes HT1000 Installation Manual

Overview of entering installation parameters

Chapter 3 • Installing the satellite modem
26
1039110-0001 Revision A
2. Make sure that neither the satellite modem or the customer's computer are
connected to an Ethernet modem or switch.
3. If you are running firewall software on the laptop computer, disable it until you
complete installation of the modem. The LAN LED on the front of the modem
should now be on.
Successful installation of the satellite modem depends on your tasks, network and
installation software, and interaction between the satellite modem and the Network
Operations Center (NOC). After powering up the modem, enter the required
parameters and then complete the antenna pointing.
The following apply to the screen illustrations in this guide:
• The screen illustrations are examples. Values shown in these illustrations may
not apply to the satellite modem you are installing. Do not use values shown to
install or configure the modem unless the instructions say to do so.
• On some screens and in some messages you may see the word modem or the
abbreviation VSAT. Both refer to the HT1000 satellite modem.
• Screen and page are both used to refer to the information displayed on your
computer monitor.
1. Open a browser on your laptop. The Your system is not quite ready screen
appears as shown in Figure 10. This is the first screen of the commissioning
process.
Figure 10: System not ready screen.