Fatal Error Indication - Hughes HX50 Installation Manual

Fatal error indication

.
Serial device
Ethernet cables to
Ethernet devices
J1-TEL J2-DEBUG
DCE serial cable
with 25-pin male
connector
G-28580 C 05/31/06
Figure 41: HX100 power and cable connections
Follow these steps if the Power LED is off and one or more of the
other LEDs is blinking:
1. Power cycle the remote terminal by unplugging the power
cord from the power source, waiting 10 seconds, and then
plugging it back in. If the problem persists, continue with
step 2.
2. Disconnect the receive and transmit cables from the remote
terminal.
If any of the LEDs illuminate and remain on, continue with
step 3.
If the Power LED is still off and one or more of the other
LEDs continue to blink, skip to Step 4.
3. Replace the receive and transmit cables that connect the
antenna assembly to the remote terminal. If the problem
persists, continue with Step 4.
Surge
protector
HX100
J6-SAT IN J7-SAT OUT
J3-LAN 1 J4-LAN 2 J5-SERIAL SYNC/ASYNC
Receive cable
Chapter 6 • Troubleshooting
1037106-0001 Revision B.03-Draft
Power
cord
J8-POWER
Transmit cable
63