Advertisement
ASSEMBLY
Place all parts of the stepper in a cleared area and remove the packing materials. Do not dispose of the packing
materials until assembly is completed. Assembly requires the included allen wrench
own phillips screwdriver
Refer to the drawings below to identify the small parts used during assembly. The number in parenthesis below
each part refers to the key number of the part, from the PART LIST on page 10. The second number refers to
the quantity required for assembly. Note: If a part is not found in the parts bag, check to see if it has been
preassembled.
M8 Nylon
Locknut (31)–4
M6 x 16mm Button
Screw (22)–4
M8 x 65mm Carriage Bolt (24)–2
1. Press an Adjustable Endcap (5) onto each end of
the Stabilizer (8).
Attach the Stabilizer (8) to the Base (2) with two M8
x 65mm Carriage Bolts (24), two Curved Washers
(25), and two M8 Nylon Locknuts (31).
, adjustable wrenches
M10 Nylon
Locknut (15)–4
Washer (25)–4
M10 x 20mm
Screw (28)–4
Curved
Large M10
Washer (21)–2
M10 x 55mm Carriage Bolt (17)–4
M8 x 60mm Carriage Bolt (27)–2
1
2
15
25
5
4
and your
and rubber mallet
M10
Washer (18)–6
15
25
8
.
5
24
Advertisement
