Config: Conv-A Or Conv-B (Converter Unit A Or Unit B) - Comtech EF Data LBC-4000 Installation And Operation Manual

LBC-4000 L-Band Up/Down Converter System
Front Panel Operation
5.2.1.1

Config: Conv-A or Conv-B (Converter Unit A or Unit B)

CONFIG CnvX(IF=YYYMHz):
Freq/Mute
Where 'X' is the selected converter – CnvA (Converter Unit A) or CnvB (Converter Unit B) – and
'YYY' indicates its operating frequency (70 or 140 MHz), use the [←][→] arrow keys to select
Freq/Mute or Atten/Slope, and then press [ENT].
CONFIG CnvA or CnvB
CONFIG CnvX:
Frq=01999.999MHz
Use the [←][→] arrow keys to select Freq, or – depending on whether the unit is an Up
Converter or Down Converter – the Rx or Tx mute status.
To set the converter's operating frequency: Use the [←][→] arrow keys to select a digit to edit,
and then use the [↑][↓] arrow keys to change that digit. Repeat for all digits until the desired
frequency has been defined.
To select the Tx/Rx mute status: Use the [←][→] arrow keys to select the mute parameter, and
then use the [↑][↓] arrow keys to select ON or OFF.
Press [ENT] when done.
CONFIG CnvA or CnvB
When Atten/Slope is selected for CnvA:
CONFIG CnvA: Ofst=+0.0dB
Atten=00.00dB Slope=0.0
For the Config: Conv‐A Atten/Slope menu, the Ofst (Gain Offset) command is
available only if redundancy is enabled. See Appendix B. LBC‐4000 REDUNDANCY
OPERATION for further details on using this command in redundancy applications.
When Atten/Slope is selected for CnvB:
CONFIG CnvB:
Atten=00.00dB Slope=0.0
For either, use the [←][→] arrow keys to select Atten or Slope.
To set the converter's attenuation: Use the [←][→] arrow keys to select a digit to edit, and then
use the [↑][↓] arrow keys to change its value.
Attn/Slope
Freq/Mute
Tx=ON
Atten/Slope
5–7
Revision 4
MN/LBC4000.IOM