G1000 System Return To Service Procedure; Display Test; Figure 9-1, Mfd Power Up Page - Garmin G1000 NXi Supplemental Maintenance Manual

9. G1000 System Return to Service Procedure

If a G1000 LRU was replaced, verify the correct LRU software part numbers and versions
against the numbers listed on the General Arrangement drawing listed in Table 1-1.
Perform the following subsection tests to confirm the G1000 system is operating correctly.
9.1

Display Test

Apply aircraft power. On the MFD power-up screen in the upper right corner, find the
'Cessna XXX System XXXX.XX' number, where XXX is the airframe type and XXXX-XX
is the number of the G1000 System Software Loader Image version number that was
used to install the software to the system. (182T image shown for reference, others are
similar)
Verify that the System Software Version is the same as listed in Table 1 of the 005-
00620-22 General Arrangement Drawing.
Press the MFD ENT key to acknowledge the 'DEFAULT PROFILE' Crew Profile option
on the MFD (NOTE: The rightmost softkey may also be used).
G1000 Supplemental Maintenance Manual
Textron Nav III Series
190-02128-04

Figure 9-1, MFD Power Up Page

Page 9-1
Revision 3