Garmin G1000 NXi Supplemental Maintenance Manual page 115

19. Highlight the software box and press the ENT key to check the box
20. Use the large FMS knob to scroll to GIA 1 – GPS or GIA 2 – GPS, whichever was
replaced.
21. Highlight the software box and press the ENT key to check the box.
22. Scroll to AUDIO.
23. Highlight the Configuration box and press the ENT key to check the box.
24. Press "Load" softkey.
25. Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete............."COMPLETE" in the summary box.
26. Acknowledge the prompt by pushing the ENT key.
GSU or GDC/GRS GIA Configuration (For GIA 1 or GIA 2 replacement)
1. Scroll the cursor to the Group window and select "0X-XXX" (where 0X is the menu
position and XXX is the airframe type).
2. Press the ENT key.
3. In the ITEM window highlight either "Baseline Option – GSU75 Installation" or
"Baseline Option – Legacy – GRS 77 and GDC 74 Installation" as applicable and
press the ENT key on the PFD.
4. Press the CLR ALL softkey.
5. Scroll the cursor to GIA1 or GIA 2 configuration box, whichever was replaced, and press
the ENT key to check the box.
6. Press "Load" softkey.
7. Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete............."COMPLETE" in the summary box.
8. Acknowledge the prompt by pushing the ENT key
GFC 700 (For GIA 1 or GIA 2 replacement) (if installed)
1. In the ITEM window highlight "Option – GFC 700 Installation" and press the ENT key
on PFD.
G1000 Supplemental Maintenance Manual
Textron Nav III Series
190-02128-04
The aircraft will be equipped with a GSU 75 ADAHRS or a
combination of GRS and GDC. If the aircraft is equipped with
the combination GRS and GDC, the installer will need to load
the GRS file then load the GDC file using the following
procedure. If the aircraft is equipped with a GSU 75, the GSU
75 is the only file that needs to be loaded.
NOTE
Page 7-10
Revision 3