Garmin G1000 NXi Supplemental Maintenance Manual page 123

Legacy Replacement Procedure GEA (Alternate Method)
To load the GEA complete the following subsections in order as they apply to the aircraft.
GEA Configuration (For GEA replacement)
1. Insert the software loader card in the top slot of the PFD.
2. Power on the MFD and PFD in configuration mode.
3. Select no when "Do you want to update system files" is displayed on the screen of PFD.
4. Select the "SYSTEM UPLOAD" page using the small FMS knob on the PFD.
5. Activate the cursor and rotate the small FMS knob to display the drop down menu.
Rotate the large FMS knob to highlight "0X - XXX" (where 0X is the menu position and
XXX is the airframe type) and press ENT key on the PFD.
6. Rotate the small FMS knob to display the drop down menu. Rotate the large FMS knob
to highlight "Cessna XXX – Baseline Configuration" (where XXX is the airframe type)
and Press ENT key on the PFD.
7. Press the CLR ALL softkey.
8. Use the large FMS knob to scroll to GEA.
9. Highlight the software box and press the ENT key to check the box.
10. Highlight the Configuration box and press the ENT key to check the box.
11. Press "Load" softkey.
12. Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete............."COMPLETE" in the summary box.
13. Acknowledge the prompt by pushing the ENT key.
CAN Bus Fuel Probe Configuration (For GEA replacement) (if installed)
1. In the ITEM window highlight "Option – CAN BUS FUEL LEVEL SENSORS" and press
the ENT key on the PFD.
2. Press the CLR ALL softkey.
3. Scroll the cursor to GEA configuration box and press the ENT key to check the box.
4. Press "Load" softkey.
5. Monitor load progress. Verify software load completes without errors as indicated by the
following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete............."COMPLETE" in the summary box.
6. Acknowledge the prompt by pushing the ENT key.
G1000 Supplemental Maintenance Manual
Textron Nav III Series
190-02128-04
Page 7-18
Revision 3