Garmin G1000 NXi Supplemental Maintenance Manual page 43

CAN Bus Fuel Level Sensors (if installed)
Follow this procedure to configure the system to use CAN Bus Fuel Level Sensors. Do not
follow the procedures in this section if the aircraft is not equipped with CAN Bus Fuel Level
Sensors.
Rotate the large FMS knob until the Item field is highlighted, rotate the small FMS knob
to activate the drop down menu. Rotate the small FMS knob and select "Option – CAN
BUS FUEL LEVEL SENSORS" and press the ENT key to select it.
Press the CHK All softkey.
In the PRODUCT window, move the cyan selection box down with the large FMS knob
to highlight the "CARD COPY" configuration check box. Press the ENT key to uncheck
the configuration check box.
Press the Load softkey.
Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
Press the ENT key to acknowledge the prompt that appears in the pop-up box.
GTS 800 without GTX 345 Software/Configuration Loading (if installed)
Follow this procedure to configure the GTS 800 Traffic System. Do not follow the procedures in
this section if the aircraft is not equipped with GTS 800 or if it is equipped with a GTS 800 and a
GTX 345.
Configuration of the GTS Processor will require entering the aircraft
registration number into the unit using Section 3.9, "Aircraft
Registration Number Entry".
Rotate the large FMS knob until the Item field is highlighted, rotate the small FMS knob
to activate the drop down menu. Rotate the small FMS knob and select "Option – GTS
800 Installation, without GTX 345" and press the ENT key to select it.
Press the CHK All softkey.
In the PRODUCT window, move the cyan selection box down with the large FMS knob
to highlight the "CARD COPY" configuration check box. Press the ENT key to uncheck
the configuration check box.
Press the Load softkey.
Monitor the loading progress and verify the software load completes without errors as
indicated by the following:
•
Green "PASS" in the Configuration and Software columns for each item loaded.
•
"Upload Complete.............COMPLETE" in the summary box.
Press the ENT key to acknowledge the prompt that appears in the pop-up box.
G1000 Supplemental Maintenance Manual
Textron Nav III Series
190-02128-04
NOTE
Page 3-23
Revision 3