Installation; Mounting And Wiring - EverFocus EBN288 Quick Installation Manual

3. Installation

This installation guide provides the basic instructions on installing an Value IP camera. For details,
please refer to the User's Manual in the software CD.

3.1 Mounting and Wiring

EBN288/368/468
1. Before screwing the camera to the wall, stick the Sticker on the wall / ceiling to mark the
position for installation. Drill four holes on the wall / ceiling according to the supplied Sticker
and push the supplied four Screw Anchors into the four holes on the wall / ceiling. Drill
another hole in the middle of the Sticker if you wish to run the wires into the wall / ceiling.
2. Twist the Outer Housing counterclockwise and then remove the Outer Housing from the
camera base.
3. Place the camera base on the wall / ceiling and run the cable through the camera base first.
4. Tread the cables:
a. From the side cut of the camera base
Value IP 288 / 368 / 468 Series
8