Io Menu - RIDGID SeekTech SR-20 Operator's Manual

IO Menu

The following section applies to the SR-24 only.
The IO feature sends the SR‑24's locate data to the in‑
ternal SD card, or to a Bluetooth device if one is avail‑
able, or to both simultaneously�
Note: Refer to the SD Card section for information about
the SD card and how to read the data log file.
Data can be logged continuously (default), or manual‑
ly at specific points during a locate, by enabling User‑
Initiated Data Output�
You can disable an entire category or specific elements
within a category� Refer to Appendix C for descriptions of
the data logging elements�
User-Initiated Data Output
The User‑Initiated Data Output function is disabled by
default� Enable User‑Initiated Data Output to set the
SR‑24 to only output data when you press the Select
Key �
To enable User‑Initiated Data Output, follow these steps:
1� Open the Settings menu and use the Down Arrow
Key to navigate to the IO icon
2� Press the Select Key
menu�
3� Highlight the Continuous
in the Data Output menu and press the
Select Key to toggle between disabled (default)
and enabled
4� Press the Menu Key
To use the User‑Initiated Data Output function during the
locate, do one of the following:
• A short press on the Select Key
shot of the instant data�
• A long press on the Select Key
shot of the data averaged�
Note: When performing a long press, the SR-24 outputs
data averaged at the same time the Depth Average re-
port displays.
48 – English
�
to open the Data Output
Data Output icon
�
to save and exit�
to output a snap‑
to output a snap‑
Data Selection
Use these menus to enable and disable specific compo‑
nents of the data output� Disable all or part of a specific
data element to reduce the amount of data that is logged
and output onto the internal SD card�
All categories of data are output by default� To disable
all or part of a specific data element, follow these steps:
1� Open the Settings menu and use the Down Arrow
Key to highlight the IO icon
2� Press the Select Key
menu�
3� Press the Down Arrow Key
egory of data that you want to disable: SIG, GPS,
or LCD�
• To disable or enable all data elements as a group
press the Select Key
abled and enabled
• Or, use the Up and Down Arrow Keys
highlight a specific data element and press the
Select Key to disable and enable the individu‑
al data element by checking and unchecking the
box next to the data abbreviation�
4� Press the Menu Key
�
to open the Data Output
to navigate to the cat‑
to toggle between dis‑
�
to save and exit�
to