Sample Parameters - Roland MC-909 Owner's Manual

Sample Edit

Sample Parameters

Here you can make various settings for the sample.
1. In the Sample Edit screen, press [F2 (Sample
Param)].
2. Use [CURSOR (up/down)] to select a parameter.
3. Use [VALUE] or [INC/DEC] to edit the value.
4. Press [F6 (Close)] when you are finished.
Parameter Values
Loop Mode FWD,
ONE-SHOT,
REV,
REV-ONE
Loop Tune -50– +50
Original Key 24 (C1)–
127 (G9)
BPM 5–300
Time Stretch TYPE01–
Type TYPE10
Start Fine 0–255
Loop Start 0–255
Fine
Loop End 0–255
Fine
116
Explanation
How the sample will be played
Refer to "About the Loop
Mode" (p. 116)
Pitch of the loop region
Make fine adjustments in
one-cent (1/100 semitone) in-
crements.
Note number that will play the
sample at the pitch at which it
was sampled
Original BPM of the sample
* You will need to edit this val-
ue when using Auto Sync.
Auto sync method
Decreasing this value will op-
timize the sound for more
rapid phrases, and increasing
this value will optimize the
sound for slower phrases.
Fine adjustment of the Start
point.
Fine adjustment of the Loop
Start point.
Fine adjustment of the End
point.
About the Loop Mode
FWD (Forward)
After the Sample played back from the Start point to the End point, it
will then be repeatedly played back in the forward direction, from
the Loop Start point to the End point.
Start
ONE-SHOT
The sample will be played back only once, from the Start
point to the End point.
Start
REV (Reverse)
When the sample has been played back from the End point to the
Start point, it will be repeatedly played back in the reverse direction,
from the Loop Start point to the Start point.
Start
REV-ONE (Reverse One-shot)
The sample will be played back only once from the End point to the
Start point in the reverse direction.
Start
Loop
Start P. End P.
Loop
Start P. End P.
Loop
Start P. End P.
Loop
Start P. End P.