About The Parameters - Roland M-480 Quick Start Manual

Functionality Added in M-480 Ver. 1.6
6.
Set the Ad-Hoc SSID
On your iPad, Select the Ad-Hoc SSID shown on the AD-HOC popup.
Example: on iPad, choose [Settings] > [Wi-Fi] > [Choose a Network] to select the Ad-Hoc SSID. A password entry screen will
appear; enter the above Ad-Hoc key.
* For details on how to connect to a wireless LAN from an iPad, refer to the iPad owner's manual.
When you have finished the Ad-Hoc mode connection, restore the iPad settings in [Settings] > [Wi-Fi] > [Choose a Network] to their previous state.

About the Parameters

• Ad-Hoc Mode
Check this to turn on the Ad-Hoc mode.
• SSID
This displays the Ad-Hoc SSID. Ad-Hoc SSID is specified by the value you have set in the [Wireless ID] of the WIRELESS LAN OPTIOIN popup.
• KEY
This displays the Ad-Hoc Key (5 characters).
• CH
This sets the Ad-Hoc mode channel (1 - 11).
Wireless ID Setting
1.
Call up the REMOTE popup (WIRELESS LAN tab)
Press [SYSTEM] > [F4 (REMOTE)] > [F6 (WIRELESS LAN)] to call up the REMOTE popup (WIRELESS LAN tab)
2.
Call up the WIRELESS LAN SETUP popup
Move the cursor to [SETUP] button and press [ENTER] to call up the WIRELESS LAN SETUP popup.
fig.call-wireless-LAN-setup.eps
3.
Call up the WIRELESS LAN OPTION popup
Press [F4 (OPTION)] to call up the WIRELESS LAN OPTION popup.
fig.wireless-LAN-option.eps
4.
Set the wireless ID
You can set the device name of this unit or the final character of the Ad-Hoc SSID to be shown on the connected application.
Normally, it should be "0". However, if you are using multiple M-480 units, you can select the wireless ID from 1 to 99. The
corresponding wireless ID and the device ID/Ad-Hoc SSID are as below.
"M-480" (default) when the Wireless ID=0
"M-480-1" when the Wireless ID=1
:
"M-480-99" when the Wireless ID=99
If you change the Wireless ID, the connection with application (M-480 Remote) is terminated temporarily.
5.
Close the popup
Press [F8 (OK)] to finalize the settings and close the popup.
8