D Beam; System Information - Roland MC-909 Owner's Manual

System

D Beam

Here you can make settings for the D Beam controller.
Parameter Range
[F1 (Solo Synth)]
Solo Synth Patch Bank Refer to Patch List (p. 151)
Solo Synth Patch No.
Solo Synth Note 0 (C-1)–127 (G9)
Solo Synth Scale FREE, CHROMATIC
Solo Synth Range 2OCTAVE, 4OCTAVE
[F2 (Cut+Reso)]
Cutoff Range Lower 0–127
Cutoff Range Upper 0–127
Resonance Range 0–127
Lower
Resonance Range Up- 0–127
per
[F3 (Turntable)]
Turntable BPM Type DOWN, UP
Turntable Pitch Type DOWN, UP
[F4 (User Assign)]
Type Control Change, Bend Up, Bend
Down, Bend Up/Down, Ch After-
touch, Start/Stop, Glissando, Adlib,
Arp Octave Up, Arp Octave Down,
Arp Octave Both, Arp Duration,
BPM Up, BPM Down, Pitch UP, Pitch
Down, Effects C1, Effects C2, All
Mute
Number CC#1–CC#31, CC#33–CC#95
Range Lower 0–127
Range Upper 0–127

System Information

Here you can view the state of the MC-909.
Press [F6 (Close)] to return to the System menu screen.
• [F1 (Features)]
Displays the main features of the MC-909.
• [F2 (Memory Info)]
Displays the amount of memory installed.
• [F3 (SRX Exp Info)]
Displays the name of the wave expansion board that is installed.
• [F4 (Version)]
Displays the version of the internal program.
130
Explanation
Patch played by the solo synth
Reference note for the solo synth
Scale on/off
FREE: Continuous (no steps)
CHROMATIC: Semitone steps
Range of the solo synth
Filter cutoff frequency when you move your hand away from the D Beam
Filter cutoff frequency when you move your hand near the D Beam
Filter resonance when you move your hand away from the D Beam
Filter resonance when you move your hand near the D Beam
How the tempo will change when you move your hand near the D Beam
DOWN: The tempo will slow down as you move your hand nearer.
UP: The tempo will speed up as you move your hand nearer.
How the pitch will change when you move your hand near the D Beam
DOWN: The pitch will fall as you move your hand nearer.
UP: The pitch will rise as you move your hand nearer.
Parameter that will be controlled by the D Beam
Control change number
This can be set only if Type is set to "Control Change."
Value of the parameter when you move your hand away
Value of the parameter when you move your hand nearer