Slicer - Roland MC-909 Owner's Manual

Multi-Effects List
26: COMPRESSOR
Flattens out high levels and boosts low levels, smoothing out
fluctuations in volume.
fig.MFX26
L in
Compressor 2-Band EQ
R in
Compressor
2-Band EQ
Parameter Value
Attack #1 0–127
Threshold 0–127
#2
Post Gain 0, +6, +12,
+18 dB
Low Gain -15– +15 dB
High Gain -15– +15 dB
Level 0–127
27: LIMITER
Compresses signals that exceed a specified volume level, preventing
distortion from occurring.
fig.MFX27
L in
Limiter 2-Band EQ
R in
Limiter
2-Band EQ
Parameter Value
Release #1 0–127
Threshold 0–127
#2
Ratio 1.5:1, 2:1,
4:1,
100:1
Post Gain 0, +6, +12,
+18 dB
Low Gain -15– +15 dB
High Gain -15– +15 dB
Level 0–127
100
L out
R out
Description
Sets the speed at which compres-
sion starts
Adjusts the volume at which com-
pression begins
Adjusts the output gain.
Gain of the low frequency range
Gain of the high frequency range
Output level
L out
R out
Description
Adjusts the time after the signal vol-
ume falls below the Threshold Lev-
el until compression is no longer
applied.
Adjusts the volume at which com-
pression begins
Compression ratio
Adjusts the output gain.
Gain of the low frequency range
Gain of the high frequency range
Output level

28: SLICER

By applying successive cuts to the sound, this effect turns a
conventional sound into a sound that appears to be played as a
backing phrase. This is especially effective when applied to sustain-
type sounds.
fig.MFX28
L in Slicer
R in
Slicer
Parameter Value
Rate #1 0.05–
10.00 Hz,
note
Attack #2 0–127
Input Sync OFF, ON
Sw
Input Sync 0–127
Threshold
Mode LEGATO,
SLASH
Shuffle 0–127
Level 0–127
Beat 0–127
1-1–4-4
L out
R out
Description
Cycle for one measure
Speed at which the volume changes
between beats
Determines whether the LFO for
switching the vowels is reset by the
input signal (ON) or not (OFF).
Volume level at which the reset be-
gins
Sets the manner in which the vol-
ume changes as one beat progresses
to the next.
LEGATO: The change in volume
from one beat's level to the next
remains unaltered. If the level of
a following beat is the same as the
one preceding it, there is no
change in volume.
SLASH: The level is momentari-
ly set to 0 before progressing to
the level of the next beat. This
change in volume occurs even if
the level of the following beat is
the same as the preceding beat.
Timing of volume changes in levels
for even-numbered Beats (Beat 1-2/
Beat 1-4/Beat 2-2/...).
The higher the value, the later the
beat progresses.
Output level
For a single measure containing
four quarter notes, this sets the level
of each sixteenth note when the
measure is divided into sixteenth
notes.
* This can be set using the sliders of
the part mixer.