Hard Disk Drive Support; Figure 16. 3.5" Hard Drive Bay - 12-Drive Configuration; Figure 17. 3.5" Drive Tray Assembly; Figure 18. Status And Activity Led On 3.5" Drive Tray - Intel JBOD 2000 Hardware Manual

Intel® Storage Server System JBOD 2000 Family Hardware Guide
3.2

3.5" Hard Disk Drive Support

The server is available in 3.5" hard disk configurations of 12 drives as illustrated below.
The drive bay can support either SATA or SAS hard disk drives. Mixing of drive types within the
hard drive bay is not supported. Hard disk drive type is dependent on the type of host bus
controller used, SATA only or SAS. Each 3.5" hard disk drive is mounted to a drive tray,
allowing for hot-swap extraction and insertion. Drive trays have a latching mechanism that is
used to extract and insert the drives from the chassis, and lock the tray in place.
Light pipes integrated into the drive tray assembly direct the light emitted from Amber drive
status and Green activity LEDs located next to each drive connector on the backplane, to the
drive tray faceplate, making them visible from the front of the system.
Revision 1.42
Figure 16. 3.5" Hard Drive Bay – 12-Drive Configuration

Figure 17. 3.5" Drive Tray Assembly

Figure 18. Status and Activity LED on 3.5" Drive Tray

Table 7. Status LED Status

Off
Solid on
Amber
Blink
System Storage and Peripheral Drive Bays Overview
No access and no fault.
Hard drive fault has occurred.
RAID rebuild in progress (1 Hz);
Identify (2 Hz).
15