Installing A Hard Disk Drive Into 3.5" Hard Drive Carrier; Figure 17. Installing Hard Disk Drive - Removing 3.5" Hdd Carrier; Figure 18. Installing Hard Disk Drive - Removing 3.5" Hdd Interface Bracket; Figure 19. Installing Hard Disk Drive - Installing 3.5" Hdd - Intel JBOD2000S3SP Service Manual

2.6.1

Installing a Hard Disk Drive into 3.5" Hard Drive Carrier

1. Remove the drive carrier by pressing the green button and opening the lever (see letter "A"). Slide the
carrier out (see letter "B").
2. Remove the four screws securing the HDD interface bracket and remove the HDD interface bracket (see
letter "C").
Figure 18. Installing Hard Disk Drive – Removing 3.5" HDD Interface Bracket
3. Install the hard disk drive using the same four screws as shown. Make sure the connector end of the
drive matches the backplane connector (see letter "D").
For installing 2.5" Hard Disk Drive as an option:
1) Break off the tab on the HDD interface bracket (see letter "d1").
2) Install the HDD interface bracket from top. Secure the bracket with three screws as shown (see letter
"d2").
3) Slide the 2.5" HDD into the bracket to align the screw holes with the right and left rail (see letter "d3").
4) Secure the hard disk drive using the four screws for 2.5" HDD (see letter "d4").
10
Intel® Storage Server System JBOD2000S3 Service Guide
Figure 17. Installing Hard Disk Drive – Removing 3.5" HDD Carrier
Figure 19. Installing Hard Disk Drive – Installing 3.5" HDD