Intel® Storage Server System JBOD 2000 Family Hardware Guide
4.3.2
Hot-Swap Backplane Power Connector
The JDOB's PDB board includes four white 2x4-pin power connectors, used to provide power to
the hot-swap backplanes. On the JBOD PDB, this connector is labeled as "HSBP PWR". The
following table provides the pin-out for this connector.
Table 10. Hot-swap Backplane Power Connector Pin-out ("HSBP PWR")
1
2
3
4
4.4
Power Supply Module Efficiency
The following table provides the required minimum efficiency level at various loading conditions.
These are provided at four different load levels: 100%, 50%, 20%, and 10%. Efficiency is tested
over an AC input voltage range of 115 VAC to 220 VAC.
Loading
Minimum efficiency
4.5
AC Power Cord Specification Requirements
The AC power cord used meets the specification requirements listed in the following table.
Revision 1.42
Pin
Signal Description
Ground
Ground
Ground
Ground
Table 11. 460 Watt Power Supply Efficiency (Gold)
100% of
Maximum
88%
Table 12. AC Power Cord Specifications
Cable Type
Wire Size
Temperature Rating
Amperage Rating
Voltage Rating
Figure 29. AC Power Cord
Pin
Signal Description
5
P12V_240VA
6
P12V_240VA
7
P12V_240VA
8
P12V_240VA
50% of
20% of
Maximum
Maximum
92%
88%
SJT
16 AWG
105ºC
13 A
125 V
Power Subsystem
10% of
Maximum
80%
25