Machine (Analyzer) Id; Figure 5-1: Setup - Comm Menu - Teledyne T100 Instruction Manual

Remote Operation & Advanced Features
Menu with
Hessen Protocol
SETUP X.X COMMUNICATIONS MENU
ID HESN COM1 COM2

5.1.1. MACHINE (ANALYZER) ID

126
SAMPLE RANGE = 500.000 PPB
< TST TST > CAL
SAMPLE ENTER SETUP PASS : 818
8 1 8
PRIMARY SETUP MENU
SETUP X.X
CFG DAS RNGE PASS CLK
SECONDARY SETUP MENU
SETUP X.X
COMM VARS DIAG
EXIT
Figure 5-1: SETUP – COMM Menu
Each type of Teledyne ML analyzer is configured with a default ID code. The default
ID code for all T100 analyzers is 100. The ID number is only important if more than
one analyzer is connected to the same communications channel such as when several
analyzers are on the same Ethernet LAN (refer to Section 5.1.2); in a RS-232 Multidrop
chain (refer to Section 3.4.8.4) or operating over a RS-485 network (refer to Section
3.4.8.5). If two analyzers of the same model type are used on one channel, the ID codes
of one or both of the instruments needs to be changed so that they are unique to the
instruments
To edit the instrument's ID code, access the Machine ID from the COMM Menu (refer
to Figure 5-1), then press:
Teledyne ML - T100 UV Fluorescence SO2 Analyzer
SO2 =XXX.X
SETUP
ENTR EXIT
MORE EXIT
EXIT
COMMUNICATIONS MENU
SETUP X.X
ID INET COM1 COM2
Menu with
Internet
Properties
EXIT