Printer Driver Problems; Cannot Print (Port Setting Problems); Cannot Print (Snmp Community Name Problems); Command Line Options Not Processed - Toshiba e-Studio2000AC Software Troubleshooting Manual

Printer Driver Problems

0.
This section describes the troubleshooting for the printer drivers.
For the error messages that appear during the installation of the printer drivers, refer to the Software Installation
Guide.
 Cannot print (port setting problems)
Problem Description
I cannot perform printing with the equipment.
Corrective Action
If the printer driver on the client computer points to a wrong network port, jobs neither appear in the current jobs
queue nor are printed. Fix the problem following the procedure below:
Open the Printers folder from the Control Panel.
1
Right-click the printer driver icon.
2
Select Printer properties from the shortcut menu.
3
Select the [Ports] tab, and then check the port is properly configured.
4
Click the [General] tab and click [Print Test Page] to confirm that the settings are correct.
5
 Cannot print (SNMP Community Name problems)
Problem Description
I cannot perform printing with the equipment.
Corrective Action
Check if the SNMP community names are the same in the following 3 settings.
 Equipment
 TCP/IP port of the [Ports] tab in the printer driver
 [SNMP Settings] dialog box of the [Others] tab in the printer driver
 Command line options not processed
Problem Description
All the print options are sent to the equipment at the beginning of the print job. If the print file already contains print
commands, they overwrite the command line options you set. For example, if the print file specifies A4 paper, and you
specify A3 paper with the lp command, the document is printed on A4 paper.
Corrective Action
Change the properties of the document you intend to print to create another print file. Submit the print job using the
lp command without setting additional parameters.

26 Printer Driver Problems