Ricoh AP305 Operating Instructions Manual page 98

Troubleshooting
Possible Cause
Is the Data In indicator
blinking or lit after start-
ing the print job?
6
Can you print a test
page (configuration
page)?
If you cannot solve the problem by taking the above actions, contact your sales
or service representative.
68
Solutions
If not, the data is not being sent to the printer. Or the printer
may be resetting the print job because there was a long de-
lay in receiving the data from the computer.
If the printer is using "I/O Timeout"
Increase the value of the "I/O Timeout" setting of the "IP-
DL-C Menu" or set the "I/O Timeout" value to "0" (this is
the off setting).
If your printer is connected to the computer using the in-
terface cable
Confirm that the printer port settings are correct. For a
parallel port connection, port LPT1 or LPT2 should be
set.
For more information on the printer port settings, see the
notes after this table.
Network Connection
Contact your network administrator.
If the Data In indicator is blinking or lit.
The printer may be resetting the print job. Take the follow-
ing steps to correct the situation.
• Increase the "Job Timeout" setting of the "IPDL-C Menu".
• Make sure your printer driver settings are correct.
• Change the setting of the "Transfer" of the "System
Menu".
• Make sure the "Parallel" of the "System Menu" is correct.
If you can't print a test page, it probably indicates a printer
malfunction. You should contact your sales or service repre-
sentative.
If you can print a test page but cannot get the printer to print
when you issue a print command from your computer, it
probably means there is a problem with your computer.
Also keep in mind that large, complex data might take long
time for the printer process.
tion Page"
P.103 "IPDL-C Menu"
P.107 "Printing the Configura-