Ricoh AP305 Operating Instructions Manual page 102

Troubleshooting
Status
It takes too much time to per-
form black and white print-
ing.
Paper isn't fed from the de-
sired paper tray.
Desired paper size isn't used
for the output.
6
Printed side gets dirty.
Image density is too light.
72
Possible Causes, Descriptions, and Solutions
[Color] is selected on the printer driver's [Setup] tab.
Change this setting to [Black & White]. See the printer
driver's online help for details about changing the set-
tings on this tab. Note, however, that some applica-
tions ignore the color mode setting made with the
printer driver.
The printer driver setting is not correct. Change the set-
ting. See the printer driver's online help for further de-
tails.
The printer driver setting is not correct. Change the set-
ting.See the printer driver's online help for further de-
tails.
Check the paper size settings. The size specified with
the paper size dial might be different from the actual
paper size. Make the correct dial setting.
ing Paper in the Paper Tray"
Specified paper is not loaded correctly in the paper
tray. Remove the paper from the tray and reload the
specified paper correctly.
Paper Tray"
The charger and dust-proofing glass are dirty. Clean
the charger and dust-proofing glass.
the Charger" and P.81 "Cleaning the Dust-proofing glass"
Check the image density setting.
Image Density"
If the message "Change PCU" appears on the panel dis-
play, replace the photoconductor unit.
ing the Photoconductor Unit"
If turning on the [Toner Saving] setting on [Quality Set-
ting] tab, it can cause blurring or fine lines might not be
printed. With color printing, toner saving can cause ab-
normal coloring. Try printing again after turning [Toner
Saving] off. See the printer driver's online help for de-
tails about changing the settings on this tab.
If the message "Add Toner XXX" is on the panel dis-
play, replace the toner cartridge for the indicated color.
P.85 "Replacing the Toner Cartridge"
You might be using paper not supported by this print-
er. Use the appropriate type of paper.
tions for Paper"
P.49 "Load-
P.49 "Loading Paper in the
P.80 "Cleaning
P.82 "Adjusting the
P.88 "Replac-
P.45 "Precau-