Ricoh AP305 Operating Instructions Manual page 46

Installing Options
G
Attach the network interface ca-
ble to the network interface con-
nector of the printer.
Important
Rating voltage of the network
interface connector for the net-
work; Max. DC 5V.
2
H
Connect the other end of the net-
work interface cable to the net-
work.
I
Plug the printer's power cord
back into the printer and the wall
socket. Turn on the printer's pow-
er switch.
J
Print a configuration page to con-
firm that the network interface
board is properly installed.
Reference
P.107 "Printing the Configura-
tion Page"
Note
You can check if the network in-
terface board is installed prop-
erly by checking the "Network"
item of the "Status List" on the
configuration page.
If the network interface board is
not properly installed, repeat
steps B to J again. If you fail
again, contact your sales or ser-
vice representative.
After installing the network in-
terface properly, set up the
printer's network environment
using the operation panel.
P.23 "Configuring the Printer for
the Network with the Operation
Panel"
16