Zoom F8n Operation Manual page 84

Input limiter
▶ Continue to one of the following procedures.
Using the limiter ................................................................P .84
Setting the type .................................................................P .85
Setting the threshold .........................................................P .86
Setting the attack time.......................................................P .86
Setting the release time ....................................................P .87
Setting the target level ......................................................P .88
On (Normal)
Before limiter
On (Advanced)
Before limiter
84
(continued)
Peak might remain
After limiter
Sudden peaks are
suppressed by detecting
maximum levels in advance
After limiter
Using the limiter
5.
Use
and press
6.
Use
setting, and press
threshold
Setting value
Off This disables the limiter.
On (Normal) This applies an ordinary limiter. The ratio is 20:1.
By detecting the maximum level in advance, this optimized
limiter prevents distortion even more than ordinary limiter
On (Advanced)
operation. The ratio is ∞:1, providing increased internal
headroom.
target
level NOTE
When sent to On (Advanced), the input latency of the
1 ms. When monitoring sounds being recorded with a mic in real-
time, increased latency can cause interference between sound
transmitted through the air from the source and the delayed mon-
itored sound, possibly making accurate monitoring of the sounds
difficult.
On/Off
to select ,
.
to select the
.
Explanation
increases