Lenovo ThinkStation P920 Hardware Maintenance Manual page 207

c. Align the four tabs at the bottom of the storage drive bay with the slots on the new blind-connect
board. Then, press down the board and slide it as shown until it snaps into position.
Figure 175. Installing the blind-connect assembly
d. Connect the cables of the blind-connect assembly to the system board or the RAID adapter. See
"Parts on the system board" on page 38.
• If the computer has a RAID adapter installed, connect the cable with the S/X silkscreen to the
mini-SAS connector on the RAID adapter. If no RAID adapter is installed, connect the cable to the
mini-SAS connector (
2
• Connect the I C cable to the BCA connector (
• Connect the power cable to the 4-pin power connector (
7. Slide the storage drive bracket back into the storage drive bay until the bracket snaps into position.
Figure 176. Installing the storage drive bracket
44 or 43 ) on the system board.
34 or 21 ) on the system board.
17 or 32 ) on the system board.
.
Chapter 9 Hardware removal and installation
199