Lenovo ThinkStation P920 Hardware Maintenance Manual page 196

Figure 155. Installing the card reader in the flex module
7. Position the flex module cover on the flex module. Ensure that the rail guides on the bottom of the flex
module cover engage the rails on the flex module. Then, push the cover to the front of the flex module
until it snaps into position.
Figure 156. Reinstalling the flex module cover
8. Install the flex module into the flex bay. See "Device in a flex bay" on page 109.
9. Refer to the recorded information about the cable connections and routing. Reconnect all cables
connected to the flex module to the system board. For the card reader, connect the card reader cable to
the 15-in-1 card reader connector
38.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 210.
eSATA connector or IEEE 1394 connector
To remove or install an eSATA connector or IEEE 1394 connector in the flex module, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 103.
2. Record the cable connections and cable routing. Then, disconnect all cables connected to the flex
module from the system board. See "Parts on the system board" on page 38.
3. Remove the flex module from the front of the computer. See "Device in a flex bay" on page 109.
188
P920 Hardware Maintenance Manual
39 on the system board. See "Parts on the system board" on page