Blind-Connect Assembly - Lenovo ThinkStation P920 Hardware Maintenance Manual

• "Full-length PCIe card" on page 163 (if necessary)
• "Multi-function bracket in the upper position" on page 173
5. Locate the VROC upgrade key module on the system board. See the VROC connector
the system board" on page 38.
6. Remove the VROC upgrade key module as shown.
Figure 169. Removing a VROC upgrade key module
7. Note the orientation of the new VROC upgrade key module. Install the VROC upgrade key module to the
VROC connector on the system board.
Figure 170. Installing a VROC upgrade key module
8. Reinstall all parts that you have removed one by one in the reversed sequence as you remove them.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 210.

Blind-connect assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To remove or install a blind-connect assembly, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 103.
2. Locate the storage drive bay from which you want to remove or install a blind-connect assembly. See
"Internal storage drives" on page 40.
.
Chapter 9 Hardware removal and installation
23 in "Parts on
195