b. Pivot the tab
1
of the metal adapter upward. Then, push the adapter as shown until the four tabs on
the adapter are slide into the notches
drive from the converter.
Figure 68. Removing the adapter from the converter
c. Flex both sides of the adapter to release the four pins
storage drive from the adapter.
Figure 69. Removing the storage drive from the adapter
5. To install a 2.5-inch storage drive with the converter, do the following:
a. Flex both sides of the bracket to remove the converter from the bracket.
b. Pivot the tab
1
of the metal adapter upward. Then, push the adapter as shown until the four tabs on
the adapter are slide into the four notches
converter.
Figure 70. Removing the adapter from the converter
2
. Pivot the adapter as shown to remove it with the storage
1
from the storage drive. Then, remove the
2
. Pivot the adapter as shown to remove it from the
Chapter 9
.
Hardware removal and installation
135