Lenovo ThinkStation P920 Hardware Maintenance Manual page 198

b. Place the eSATA connector or IEEE 1394 connector into the metal retainer. Then, insert the eSATA
connector or IEEE 1394 connector into the corresponding slot in the flex module as shown.
Figure 159. Installing the eSATA connector or IEEE 1394 connector in the flex module
7. Position the flex module cover on the flex module. Ensure that the rail guides on the bottom of the flex
module cover engage the rails on the flex module. Then, push the cover to the front of the flex module
until it snaps into position.
Figure 160. Reinstalling the flex module cover
8. Install the flex module into the flex bay. See "Device in a flex bay" on page 109.
9. Refer to the recorded information about the cable connections and routing, reconnect all cables
connected to the flex module to the system board. See "Parts on the system board" on page 38. For the
eSATA connector or IEEE 1394 connector, connect the cables to the system board as follows:
• Connect the eSATA connector to the eSATA connector on the system board.
• Connect the IEEE 1394 connector cable to the IEEE 1394 adapter.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 210.
Front Thunderbolt adapter kit
The front Thunderbolt adapter kit includes the following parts:
• A front Thunderbolt I/O adapter
190
P920 Hardware Maintenance Manual