Verification; Configuring An Attachment Circuit On A Vlan - Cisco NCS 5500 Series Configuration Manual

Configuring an Attachment Circuit on a VLAN

Example:
RP/0/RP0/CPU0:router# show ethernet trunk bundle-ether 5
(Optional) Displays the interface configuration.
The Ethernet bundle instance range is from 1 through 65535.

Verification

This example shows how to verify the configuration of Ethernet interfaces :
# show ethernet trunk be 1020 Wed May 17 16:43:32.804 EDT
Trunk
Interface
BE1020
Summary
Configuring an Attachment Circuit on a VLAN
Use the following procedure to configure an attachment circuit on a VLAN.
SUMMARY STEPS
1. configure
2. interface [GigabitEthernet | TenGigE | Bundle-Ether | FortyGigE] interface-path] id.subinterface
l2transport
3. encapsulation dot1q 100
4. end or commit
5. show interfaces [GigabitEthernet |FortyGigE|Bundle-Ether | TenGigE] interface-path-id.subinterface
DETAILED STEPS
Step 1
configure
Example:
RP/0//CPU0:router# configure
Enters global configuration mode.
Step 2 interface [GigabitEthernet | TenGigE | Bundle-Ether | FortyGigE] interface-path] id.subinterface l2transport
Example:
RP/0//CPU0:router(config)# interface TenGigE 0/1/0/0.1 l2transport
Enters subinterface configuration and specifies the interface type, location, and subinterface number.
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release
6.1.x
150
St Ly MTU Subs
Up L3 9100 3
3
Sub types Sub states
L2 L3 Up
3 0 3
3 0 3
Configuring 802.1Q VLAN Interfaces
Down Ad-Down
0 0
0 0