Configuring Cross-Check On A Mep For A Cfm Service - Cisco NCS 5500 Series Configuration Manual

Configuring Ethernet OAM
Command or Action
Step 5
mip auto-create {all | lower-mep-only}
{ccm-learning}
Example:
RP/0/RP0/CPU0:router(config-cfm-dmn-svc)#
mip auto-create all ccm-learning
Step 6 end or commit
Example:
RP/0/RP0/CPU0:router(config-cfm-dmn-svc)#
commit

Configuring Cross-Check on a MEP for a CFM Service

To configure cross-check on a MEP for a CFM service and specify the expected set of MEPs, complete the
following steps:
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.1.x
Purpose
(Optional) Enables the automatic creation of MIPs in a bridge domain.
ccm-learning option enables CCM learning for MIPs created in this
service. This must be used only in services with a relatively long CCM
interval of at least 100 ms. CCM learning at MIPs is disabled by default.
Saves configuration changes.
• When you use the end command, the system prompts you to
commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
• Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and returns the
router to EXEC mode.
• Entering no exits the configuration session and returns the router
to EXEC mode without committing the configuration changes.
• Entering cancel leaves the router in the current configuration
session without exiting or committing the configuration changes.
• Use the commit command to save the configuration changes to
the running configuration file and remain within the configuration
session.
Configuring Ethernet CFM
53