Configuring Vpws Cross-Connects In Mc-Lag - Cisco NCS 5500 Series Configuration Manual

Configuring VPWS Cross-Connects in MC-LAG

Example:
RP/0/RP0/CPU0:router# show bundle Bundle-Ether 3 reasons
(Optional) Shows information about the specified Ethernet link bundle.
The show bundle Bundle-Ether command displays information about the specified bundle. If your bundle has been
configured properly and is carrying traffic, the State field in the show bundle Bundle-Ether command output will show
the number "4," which means the specified VLAN bundle port is "distributing."
Step 26 show ethernet trunk bundle-ether instance
Example:
RP/0/RP0/CPU0:router# show ethernet trunk bundle-ether 5
(Optional) Displays the interface configuration.
The Ethernet bundle instance range is from 1 through 65535.
Configuring VPWS Cross-Connects in MC-LAG
Perform this task to configure VPWS cross-connects in MC-LAG.
SUMMARY STEPS
1. configure
2. l2vpn
3. pw-status
4. xconnect group group-name
5. p2p xconnect-name
6. interface type interface-path-id
7. neighbor A.B.C.D pw-id pseudowire-id
8. pw-class {class-name}
9. backup neighbor A.B.C.D pw-id pseudowire-id
10. pw-class {class-name}
11. end or commit
DETAILED STEPS
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters global configuration mode.
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release
6.1.x
114
Configuring Link Bundling