Interface And Hardware Component Configuration Guide For Cisco Ncs 5500 Series Routers, Ios Xr Release - Cisco NCS 5500 Series Configuration Manual

Preconfiguring Physical Interfaces
SUMMARY STEPS
1. configure
2. interface preconfigure type interface-path-id
3. Use one of the following commands:
4. Configure additional interface parameters, as described in this manual in the configuration chapter that
applies to the type of interface that you are configuring.
5. end or commit best-effort
6. show running-config
DETAILED STEPS
Step 1 configure
Example:
RP/0/RP0/CPU0:router#configure
Enters global configuration mode.
Step 2 interface preconfigure type interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface preconfigure HundredGigE 0/3/0/2
Enters interface preconfiguration mode for an interface, where type specifies the supported interface type that you want
to configure and interface-path-id specifies the location where the interface will be located in rack/slot/module/port
notation.
Step 3 Use one of the following commands:
• ipv4 address ip-address subnet-mask
• ipv4 address ip-address/prefix
Example:
RP/0/RP0/CPU0:router(config-if-pre)# ipv4 address 192.168.1.2/31
Assigns an IP address and mask to the interface.
Step 4 Configure additional interface parameters, as described in this manual in the configuration chapter that applies to the
type of interface that you are configuring.
Step 5
end or commit best-effort
Example:
RP/0/RP0/CPU0:router(config-if-pre)# end
• ipv4 address ip-address subnet-mask
• ipv4 address ip-address/prefix
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.1.x
How to Preconfigure Physical Interfaces
5