Modifying The Mac Address For A Management Ethernet Interface - Cisco NCS 5500 Series Configuration Manual

Modifying the MAC Address for a Management Ethernet Interface

MTU is 1514 (1500 is available to IPv6)
ICMP redirects are disabled
ICMP unreachables are enabled
ND DAD is enabled, number of DAD attempts 1
ND reachable time is 0 milliseconds
ND cache entry limit is 1000000000
ND advertised retransmit interval is 0 milliseconds
Hosts use stateless autoconfig for addresses.
Outgoing access list is not set
Inbound
Table Id is 0xe0800000
Complete protocol adjacency: 0
Complete glean adjacency: 0
Incomplete protocol adjacency: 0
Incomplete glean adjacency: 0
Dropped protocol request: 0
Dropped glean request: 0
Modifying the MAC Address for a Management Ethernet Interface
Perform this task to configure the MAC layer address of the Management Ethernet interfaces for the RPs.
SUMMARY STEPS
1. configure
2. interface MgmtEth interface-path-id
3. mac-address address
4. end or commit
DETAILED STEPS
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Enters global configuration mode.
Step 2 interface MgmtEth interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface MgmtEth 0/RP0/CPU0/0
Enters interface configuration mode and specifies the Management Ethernet interface name and instance.
Step 3 mac-address address
Example:
RP/0/RP0/CPU0:router(config-if)# mac-address 0001.2468.ABCD
Configures the MAC layer address of the Management Ethernet interface.
• To return the device to its default MAC address, use the no mac-address address
Note
command.
Step 4 end or commit
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release
6.1.x
14
Advanced Configuration and Modification of the Management Ethernet Interface
common access list is not set, access list is not set