Access Via Ftp - THOMSON SpeedTouch 605 User Manual

Chapter 1
Getting to know your SpeedTouch™

1.2.3 Access via FTP

To access the
SpeedTouch™ via the
File Transfer Protocol
File system
To open an FTP session
File system structure
10
You can access the file system of the SpeedTouch™ via the File Transfer Protocol
(FTP), in order to:
Restore or back up configuration files, templates or language packs.
(FTP)
Upgrade your configuration or firmware.
The SpeedTouch™ file system is stored on non-volatile memory and contains the
SpeedTouch™ software, service template files and (optionally) default setting files.
Proceed as follows:
1
Open a Command Prompt window.
In Microsoft Windows XP for instance:
1
2
2
At the prompt, type
(192.168.1.254 by default).
3
Enter your SpeedTouch™ security user name and password.
The default user is 'Administrator' and the default password is blank.
The example below shows an FTP session to the SpeedTouch™ file system.
The structure of the file system is very simple: it consists of a single root directory
called root and two subdirectories called
The root directory contains:
all the necessary files for the SpeedTouch™ to start correctly
the active and the dl directories
The active directory contains the active software image.
The dl directory contains the passive software image.
If you made changes to the SpeedTouch™ configuration and saved
them, a user.ini configuration settings file is created in the
subdirectory.
On the Windows taskbar, click Start.
Select ( All) Programs > Accessories > Command Prompt
ftp
followed by the IP address of your SpeedTouch™
active and dl (download).
dl
E-DOC-CTC-20051017-0151 v1.0
.