THOMSON SpeedTouchTM706 User Manual page 26

Chapter 2
Local Network Setup
To install Windows USB
18
The first time you connect the SpeedTouch™ to your computer through the USB
drivers port, you will be prompted for a USB driver as soon as you plug the USB cable into
the computer.
You can find the required USB driver software on the Setup CD. The installation is
Plug and Play, meaning that installation requires almost no effort.
Proceed as follows:
1
Insert the blue USB cable into the SpeedTouch™ USB port marked with the
USB logo:
A USB logo looks like this:
2
Insert the other end of the USB cable into (one of) the USB port(s) of your
computer. In most cases your computer's USB port is marked with the same
USB symbol.
You can also connect your computer to the SpeedTouch™ via a USB
hub.
Microsoft Windows will automatically recognise the Thomson USB Remote
NDIS device.
The Windows Found New Hardware Wizard appears:
This wizard will guide you through the installation procedure of the USB
drivers.
3
Click Next to continue.
The Windows Found New Hardware Wizard may ask your
authorisation to connect to Windows Update to search for software. If
this is the case, select No, not this time, and then click Next.
4
Select Install the software automatically (Recommended), and then click
Next.
The USB driver is being installed. After a while a completing dialogue will
appear.
5
Click Finish to complete the installation.
Your USB connection is installed and ready for use.
E-DOC-CTC-20051017-0148 v1.0