90
gramme diagnostic cable ⇒ Current Flow Diagrams,
Electrical Fault Finding and Fitting Locations.
or
or
or
–
Move forward in the programme with the key
Self-diagnosis functions
The following functions are possible:
02 - Interrogating fault memory ⇒ 90-5 page 2
03 - Final control diagnosis ⇒ Chap. 90-6
05 - Erasing fault memory ⇒ 90-5 page 3
06 - Ending output ⇒ 90-5 page 3
07 - Coding control unit ⇒ Chap. 90-6
08 - Reading measured value block ⇒ Chap. 90-7
10 - Adaptation ⇒ Chap. 90-7
11 - Log-in procedure ⇒ Chap. 90-4
Interrogating fault memory
Note
The fault information displayed is not constantly updated,
but only when self-diagnosis is initiated, or with the func-
tion 05 „Erase fault memory".
Readout on display:
–
Enter function
0 2
and confirm entry with
The number of faults stored appears on the display.
The stored faults are displayed in sequence.
–
Find the fault message displayed in the fault table and
rectify the fault ⇒ Chap. 90-6.
If „No fault detected" the program returns to its initial po-
sition after key
is pressed.
Readout on display:
If anything else appears on the display: ⇒ Operating in-
structions of the vehicle system tester.
End output (Function 06) ⇒ 90-5 page 3.
–
90-5
2
page
for „Interrogate fault memory"
.
Q
Self-diagnosis of the electric system control unit I
Vehicle system test
Fault in communication build-up
Vehicle system test
K cable does not connect to earth
Vehicle system test
K cable doest not connect to pos. term.
.
Vehicle system test
Select function XX
X faults detected!
No fault detected!
Vehicle system test
Select function XX
FABIA 2000
Electrical System
->
Edition 06.01
S00.5304.05.20
HELP
HELP
HELP
HELP
HELP