90
Information on replacing the dash panel insert
♦
The dash panel insert must not be disassembled.
♦
If a replacement dash panel insert is fitted, the odom-
eter reading and the service interval display can be
adapted using the vehicle system tester -V.A.G 1552-
⇒ Chap. 90-4.
The immobilizer must be reset ⇒ Chap. 96-1.
♦
If the control unit in the dash panel insert detects a fault
in the programmed memory, the read-out „dEF" appears
in the trip counter.
–
If the read-out „dEF" appears, replace the dash panel
insert ⇒ Chap. 90-1.
Initiating self-diagnosis of the dash pan-
el insert
Special tools, test and measuring equipment and
auxiliary items required
♦
Vehicle system tester -V.A.G 1552-
♦
Diagnostic cable -V.A.G 1551/3-
Test requirements
•
Always check the coding of the dash panel insert by
referring to the table of codes ⇒ Chap. 90-3.
Test conditions
•
Fuses o.k.
•
Battery voltage at least 11 volts
•
All electrical components must be switched off.
Connecting vehicle system tester -V.A.G 1552-
The diagnostic connection is located on the left next to
the storage compartment on the driver's side.
–
Unclip cover and remove downward.
–
Connect vehicle system tester -V.A.G 1552- with di-
agnostic cable -V.A.G 1551/3-.
–
Switch on ignition.
Readout on display:
Note
If there is no readout on the display: ⇒ Operating instruc-
tions of the vehicle system tester.
–
Enter address word
1 7
firm entry with the
Q
Readout on display:
♦
6Y1919870B: Number or the dash panel insert
♦
COMBIINSTRUMENT: Designation of component
90-2
2
page
„dash panel insert" and con-
key.
Self-diagnosis of the dash panel insert I
FABIA 2000
V.A.G 1552
V.A.G 1551/3
Vehicle system test
Enter address word XX
6Y1919870B COMBIINSTRUMENT VDO X09
Coding
20141
Electrical System
S01-0087
HELP
->
WSC
xxxxx
Edition 10.03
S00.5304.10.20