FABIA 2000
Electrical System
27-3
Alternator
Removing and installing the alternator
Fixing the B+ wire to the generator
Tightening torque for the fixing nut of the B+ cable -arrow-
is 15 Nm.
Note
♦
The screw connection for the B+ cable at the compact
generator is identified with B1+!
♦
If the B+ cable is not attached with the specified tight-
ening torque, this may result in the following risks:
♦
The battery will not charge fully.
♦
Complete failure of vehicle electrics/electronics
(breakdown).
♦
Risk of fire resulting from sparking.
♦
Damage resulting from overvoltages on electronic
components and control units.
Checking the carbon brushes of the AC
generator
Length of carbon brushes when new = 12 mm
Wear limit = 5 mm
Tolerance of carbon brushes to each other = +1 mm
Removing and installing the voltage reg-
ulator
–
Unscrew the fixing nuts -arrows A- and release the fix-
ing screw -arrow B- of the protective cap.
–
Remove the protective cap.
Edition 04.01
S00.5304.04.20
A
Alternator
A
B
27-3
27
N27-0174
N27-0175
N27-0172
1
page