90
The number of faults stored appears in the display.
The stored faults are displayed in sequence.
–
Find the fault displayed in the fault table and rectify the
fault ⇒ Chap. 90-3.
If „No fault detected" is shown in the display and if the key
is pressed, the programme returns to the initial posi-
tion.
Readout on display:
If anything else appears on the display: ⇒ Operating in-
structions of the vehicle system tester.
End output (Function 06) ⇒ 90-2 page 4.
–
Erasing fault memory
Note
The contents of the fault memory are output automatically
after the fault memory is erased. If it is not possible to
erase the fault memory, interrogate the fault memory
once again and rectify any faults.
Requirements:
•
Fault memory was interrogated ⇒ 90-2 page 3.
•
All faults were rectified.
After interrogating the fault memory:
Readout on display:
–
Select function
0 5
firm with
.
Q
Readout on display:
The fault memory is now erased.
–
Press
.
Readout on display:
Note
♦
If the following message is displayed the test se-
quence is incorrect.
♦
Carefully follow the test sequence step by step: first
interrogate the fault memory, if necessary rectify faults
and then erase the fault memory.
Ending output
–
Select function
0 6
.
Q
Readout on display:
–
Switch off ignition.
90-2
4
page
„Erase fault memory" and con-
„End output" and confirm with
Self-diagnosis of the dash panel insert I
FABIA 2000
X faults detected!
No fault detected!
Vehicle system test
Select function XX
Vehicle system test
Select function XX
Vehicle system test
Fault memory erased!
Vehicle system test
Select function XX
Vehicle system test
Fault memory was not interrogated
Vehicle system test
Enter address word XX
Electrical System
->
HELP
HELP
->
HELP
->
HELP
Edition 10.03
S00.5304.10.20